CDJ-800MK2 Firmware

This update will improve the Master Tempo performance, improve readability of dirty or scratched discs and improves loop performance and better disc recognition (CD-R – CDDA).
You'll only need to update your CDJ-800MK2 if it has a System Version lower than 2.10.

Just follow the five easy steps below:

 

1. CHECK WHICH VERSION OF THE CDJ-800MK2 YOU OWN

• Turn the player on.
• Press down the RELOOP/EXIT button for 10 seconds. The system version will appear on the player's display.
• Remember, you'll only need to update if your System has a Version lower than 2.10.
• To return the CDJ-800MK2 player to its normal operating state, turn the player off and then on again.

2. DOWNLOAD THE FIRMWARE

• The file is 2.68MB and was released on 15 April 2008
• If your browser does not automatically start the download process, be sure that your browser or security software is set to allow downloading of files from this web site.
• You can also right-click the link and select “Save Target As” to start the download process.

3. CHECK THE FIRMWARE FILE

Check the size (2.68MB) of the downloaded firmware file CDJ800MK2_V2.10.iso by right-clicking on the file and selecting Properties. (Download again if the file size is incorrect.)

4. CREATE THE UPDATE DISC

• It is important to use a good quality branded blank CD-R disc or completely erased CD-RW disc.
• Create the update disc by burning the file to a CD-R or CD-RW disc.
• Burn the file to the disc using disc-at-once mode (2x Speed) and ISO 9660 CD-ROM file system format. (The player will not recognize the update disc and the update cannot be performed if the file is not burned correctly to the disc.)
• Make sure that the disc session is closed / the disc is finalised.

5. UPDATE YOUR DEVICE

• Update the firmware using the CD-R or CD-RW disc containing the firmware file.
• Perform the update following the procedure given in the PDF CDJ-800MK2 update instructions.

Note: Do not turn off or disconnect power, or remove a disc while update is in progress.